Configuration Interface > Detailed Directions > Configuring Routers Dynamically > Salvos Tab
 
Salvos Tab
This tab permits you to create and name a configuration of crosspoint closures. Individual levels may be specified at each crosspoint, or else the entire group may be specified (all follow). These are essentially presets, and can be invoked from the operating window.
 

NOTE: Exclusions are shown on the matrix, and these cannot be overridden.

 

The following tasks can be performed on the Salvos tab:
 
 
REQUIREMENT:  
Before beginning this procedure, make sure you have opened Router Manager Configurator (click HERE).
 
 
To do this...
...do this...
Create a new salvo.
1. Click New.
 
2. In the Input window, type the name of the new salvo.
 
3. Click OK.
4. Click Save.
Rename a salvo.
1. Select the salvo you would like to rename from the list.
2. Click Rename.
 
3. In the Input window, type the new name for this salvo.
4. Click OK.
5. Click Save.
Remove a salvo from the list.
1. Select the salvo you would like to remove from the list.
2. Click Delete.
3. In the confirmation window, click OK.