Install the ATTO Fibre Channel card driver
- Open Device Manager.
- Right-click on K2 Summit Client and select Manage.
- Click Device Manager
-
Install the first Fibre Channel
driver as follows:
- Right click on the upper Fibre Channel Controller and select Update Driver…
- On the Welcome page, select No, not this time and then click Next.
- Select Install from a list or specific location and then click Next.
- Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers\x86.
- Click OK.
- Click Next.
- Click Finish when prompted.
- In the Found new hardware wizard that will open for the ATTO Phantom device, select No, not this time.
- Select Install from a list or specific location and then click Next.
- Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers and select the x86 directory if installing on a 32-bit computer or the x64 directory if installing on a 64-bit computer.
- Click OK .
- Click Next..
- Click Finish when prompted.
-
Repeat the process for the second
Fibre Channel Controller as follows:
- Right-click on the remaining Fibre Channel Controller and select Update Driver…
- On the Welcome page, select No, not this time and then click Next.
- Select Install from a list or specific location and then click Next.
- Browse to C:\Profile\Drivers\ Atto 8Gb HBA Drivers and select the x86 directory if installing on a 32-bit computer or the x64 directory if installing on a 64-bit computer..
- Click OK.
- Click Next.
- Click Finish when prompted.
- Verify that the two "ATTO" devices are now listed under the SCSI and RAID Controllers
- Close the Device Manager and System windows
Next, do final steps.