Starting a Dynamic Configuration Session

Configuration Interface > Detailed Directions > Configuring Routers Dynamically > Starting a Dynamic Configuration Session


REQUIREMENT:
Before beginning this procedure, make sure you have launched Router Manager Configurator (click HERE).

1. In Router Manager Configurator, click on the Dynamic Control tab in the left pane.

[ Graphic ]

System Response: The closed root folder name appears in the left pane.

[ Graphic ]

2. Double-click the router manager folder.

System Response: The root folder for the router manager expands to show closed folders for each of the named logical routers.

[ Graphic ]

3. Double-click one of the logical router folders.

System Response: The folder expands to show the following branches:

• Labels

• Groups of destinations

• Exclusions

• Monitoring outputs

• Salvos

System Response: The right pane shows a General Information tab, which reports router name, number of sources and destinations, and defined levels, as well as five other tabs which open windows allowing configuration of the operating controls and system functionality. These tabs repeat the names of the branches, as follows:

• Labels (click HERE)

• Groups (click HERE)

• Exclusions (click HERE)

• Monitoring Outputs (click HERE)

• Salvos (click HERE)


NOTE: The branch name Groups of Destinations is shortened to Groups in the tab.

[ Graphic ]