Mark points are used to determine the length of a clip.
- Find the spot on the videotape where you want
your clip to begin.
- Mark an In Point using any of the following methods:
- Press I on your keyboard.
- Click the
Mark
In button
on the GV STRATUS VTR Ingest window.
- Type the timecode in the In field.
- Create a Mark In on the VTR.
- Play through the tape until you reach the point where
you want the clip to end.
- Mark an Out Point using any of these methods:
- Press O on your keyboard.
- Click the
Mark
Out button
on the GV STRATUS VTR Ingest window.
- Use the up or down arrows to find the correct timecode.
- Type the ending timecode in the Out field.
- Create a Mark Out on the VTR.